Mbt-lighting CA1612 Manual do Utilizador descarregar pdf (Página 5)

Dip Switch no.1

is not used with DMX but normally to select some

functions,i.e. Master/Slave,Sound activation, etc.

Each of the 12 fixtures is assigned 16 channels.The Dip switches are set

as per the chart below:

Scanners Channels Dip switches on

1 1~16 0 or 1 based on scanner

2 17~32 1,5

3 33~48 1,6

4 49~64 1,5,6

5 65~80 1,7

6 81~96 1,5,7

7 97~112 1,6,7

8 113~128 1,5,6,7

9 129~144 1,8

10 145~160 1,5,8

11 161~176 1,6,8

12 177~192 1,5,6,8

Note:

When addressing your fixtures,follow the starting address in this

instruction not the addressing found in your fixture user manual.

1.)Pressand hol

button for three seconds to activate programProgram

mode . The LCD next to''Program''blinks,indicating the program has

been started.

2.)Select a fixture to program,by pressing any or all buttons 1 to 12.Scanner

3.)Adjust the faders to the desired output level for all channels(i.e.Color,

Gobo,Pan,Tilt, etc.) of selected fixture or fixtures.Press Page Select

A/B if the fixture has more than 8channels.When selecting from PageA

to B,you have to move sliders to activate channels.

4.)If you have set the fixture to your liking and wish to program another

fixture,press the button you have finished adjusting.Scanner

This will hold the fixture in its final configuration.Select another fixture/s

by pressing the target button and proceed to adjust the fadersScanner

to achieve the settings you desire.

5.)Repeat steps2 and 3 until you have set the fixtures the way you like.

6.)When entire scene is set to your liking,press and release the MIDI/Add

button.

7.)Select the desired bank to store scene using the Up and Down Bank

select button.There are 30 banks you can store up to 8scenes per bank

for a total of 240 scenes.

SceneProgramming

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Mbt-lighting CA1612 Manual do Utilizador Página 5